F 250 2WD Super Duty V10-6.8L (2009)
Transmission Mount: Service and Repair
Transmission Support Crossmember
TorqShift
Transmission Support Crossmember
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Install a suitable high-lift transmission jack.
3. Remove the wire harness from the crossmember.
4. NOTE: The transmission insulator studs may come out of the insulator while removing the nuts. Install new insulator studs if the studs come out
of the insulator.
Remove the transmission insulator-to-crossmember nuts.
5. Remove the LH support crossmember-to-frame bolts and nuts.
1. Loosen, but do not remove, the bolt and nut indicated.
6. Remove the RH support crossmember-to-frame bracket bolts and nuts.
1. Remove the bracket bolts and nuts.
2. Remove the bracket.
7. Remove the RH support crossmember-to-frame bolts and nuts.
