F 250 2WD Super Duty V10-6.8L (2009)
Windshield Washer Reservoir: Service and Repair
Washer Reservoir
Removal and Installation
WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice.
For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result
in serious personal injury.
NOTICE: When servicing the windshield washer pump, be careful not to damage the windshield washer pump seal.
NOTICE: Do not operate the windshield pump before filling the windshield washer reservoir. Failure to do so could result in premature pump
failure.
NOTE: The washer reservoir is integrated with the battery tray and cannot be serviced separately.
1. Remove the vehicle battery.
2. Remove the 3 windshield washer reservoir bolts.
-
To install, tighten to 17 Nm (150 lb-in).
3. Carefully position the washer reservoir assembly as necessary to gain access to the electrical connector and washer hose.
-
Remove any wiring harness pushpins from the washer reservoir/battery tray assembly.
4. Disconnect the windshield washer pump electrical connector and washer hose.
5. NOTE: If necessary, drain the windshield washer reservoir after removal.
Remove the washer reservoir assembly.
6. Transfer components as necessary.
7. To install, reverse the removal procedure.
