F 250 2WD Super Duty V10-6.8L VIN S (1999)
Brake Rotor/Disc: Service and Repair
Brake Rotor/Disc
Front
Disc-F-250, F-350.
Removal
1. Remove the front disc brake caliper anchor plate.
2. Remove the front disc brake rotor as follows:
1
Remove the hub grease cap.
2
Remove the cotter pin.
3
Remove the nut retainer.
4
Remove the spindle nut.
5
Remove the front wheel outer bearing retainer washer.
6
Remove the outer front wheel bearing.
7
Remove the front disc brake hub and rotor.
3. If necessary, resurface the front disc brake hub and rotor. Ford recommends on-vehicle rotor machining.
1
Remove the wheel hub grease seal.
2
Remove the inner front wheel bearing.
Installation
1. Thoroughly clean and inspect the front wheel bearings and the front disc brake hub and rotor.
-
Use Metal Brake Parts Cleaner F3AZ-19579-SA, (PM-4) or equivalent.