F 250 2WD Super Duty V10-6.8L VIN S (1999)
4. Using a floor crane remove the Three Bar Engine Support.
5. Lower the engine and align the engine mount studs.
6. Remove the floor crane.
7. Raise and support the vehicle.
8. Install the nuts.
9. Lower the vehicle.
10. Remove the Modular Engine Support Bracket from the engine.
11. Install the generator.
12. Install the fan shroud.
13. Install the throttle body adapter
^
Position a new throttle body adapter gasket.
^
Position the throttle body adapter.
^
Install four bolts and tighten in two stages.