F 250 2WD Super Duty V10-6.8L VIN S (1999)
8. Remove the pinion hex nut using a suitable torque multiplier.
9. CAUTION: Hammering on the companion flange will close in the bearing bores and misalign the flange lugs. This will result in
premature failure of the journal needle bearings to other driveline components. Serious damage will also occur internally to the ring and
pinion set/pinion bearings by hammering on external parts.
Remove the companion flange using the Yoke Remover.
10. Install the pinion seal using the Pinion Seal Installer Set.
^
A rotational torque of 1.6947 - 5.0841 Nm (15 - 45 inch lbs.) is acceptable with the pinion seal installed.
11. Install the companion flange using the Yoke Installer.