F 250 2WD Super Duty V10-6.8L VIN S (1999)
1. WARNING: Replace with new bolts after the third removal.
NOTE: Prior to the third removal, clean the bolt threads and apply Loctite(R) 242 or equivalent. Install driveshaft to parking brake drum bolts.
Connect the front driveshaft to the transmission.
^
Hand tighten only; do not tighten at this time.
2. Position the center support bearing and install the bolts.
^
Hand tighten only; do not tighten at this time.
3. Tighten the driveshaft to parking brake drum bolts and the driveshaft center bearing bolts.