F 250 2WD Super Duty V8-5.4L (2008)
Part 2
Removal and Installation
1. NOTE: The window must be in the raised position.
Remove the exterior front door handle.
2. Disconnect the push button rod from the front door latch.
3. Release the front door latch actuating cable locators.
4. Remove the 3 screws and position the front door latch aside.
-
To install, tighten to 12 Nm (106 lb-in).
5. Disconnect the front door latch electrical connector(s).
6. Remove the front door latch cable water seal.
7. Remove the front door latch.
-
Release the cable conduit.
-
Release the cable.
8. To install, reverse the removal procedure.