F 250 2WD Super Duty V8-5.4L (2008)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Removal and Installation
CAUTION: Clean off any dirt or foreign material that may have collected around the wheel speed sensor before removal to prevent
contamination of the axle lubricant. Failure to follow this instruction may result in damage to the rear axle.
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
2. Disconnect the wheel speed sensor electrical connector.
3. CAUTION: The wheel speed sensor is constructed from plastic, excessive force may damage the wheel speed sensor.
Remove the wheel speed sensor bolt and the sensor.
^
To install, tighten to 20 Nm (15 lb-ft).
4. To install, reverse the removal procedure.