F 250 2WD Super Duty V8-5.4L (2008)
![background image](/ford/f_250_2wd_super_duty/v8-5.4l/Page-694001.png)
Valve Seat: Service and Repair
Valve Seat Inspection
Valve and Seat Refacing Measurements
NOTE: Refer to the appropriate information for the specification.
NOTE: After grinding valves or valve seats, check valve clearance.
1. Check the valve head and seat.
^
Check valve angles.
^
Check margin width.
^
Be sure margin width is within specification.
2. Inspect for abnormalities on the valve face and seat. Install a new cylinder head assembly if abnormalities are found.
Valve Seat Width
NOTE: Refer to the appropriate information for the specification.
1. Measure the valve seat width. If necessary, grind the valve seat to specification.
^
Measure the intake valve seat width.
^
Measure the exhaust valve seat width.
^
Recheck the valve spring installed length after the seats have been ground, and shim the valve springs as necessary to achieve the correct
installed spring length.
Valve Seat Runout
NOTE: Refer to the appropriate information for the specification.
1. Use a valve seat runout gauge to check valve seat runout.