F 250 2WD Super Duty V8-5.4L (2008)
4. Connect the engine wiring harness retainer to the CMCV stud and install the nut.
^
Tighten to 10 Nm (89 lb-inch).
5. Connect the CMCV electrical connector.
6. Connect the HO2S electrical connector and attach the electrical connector retainer.
7. Connect the CHT sensor jumper harness electrical connector.
8. Connect the LH and RH KS electrical connectors.
9. Connect the intake manifold vacuum tube to the support bracket and the valve cover stud.
10. Connect the brake booster vacuum hose to the intake manifold vacuum tube.
11. Position the engine wiring harness and connect the wiring harness retainers to the LH valve cover stud bolts.
12. Connect the LH radio ignition interference capacitor electrical connector.
13. Connect the LH VCT solenoid electrical connector.
14. Connect the heated PCV intake fitting electrical connector.
15. Connect the TP sensor and electronic acceleration control electrical connectors.
16. Connect the 8 fuel injector electrical connectors.
17. Connect the fuel rail pressure and temperature sensor electrical connector and vacuum connector.
18. Position the air cleaner outlet pipe-to-throttle body (TB) adapter and install the 4 bolts.
^
Tighten to 10 Nm (89 lb-inch).
19. Connect the fuel supply spring lock coupling to the fuel rail.
20. Position the PCV tube and connect the quick connect couplings.
21. Connect the EVAP tube quick connect coupling to the intake manifold.
22. Connect the heater coolant hose to the engine coolant crossover manifold assembly.