F 250 2WD Super Duty V8-5.4L (2008)
All vehicles
6. Remove the 3 screws and the steering column lower shroud.
7. Remove the steering column upper shroud.
8. Remove the steering column lower shroud.
9. CAUTION: Make sure each of the 3 driver air bag module wire clips are disengaged from each of the 3 steering wheel hooks before
removing the driver air bag module from the steering wheel. Failure to follow this instruction may result in component damage and/or
system failure.
NOTE:
-
Steering wheel is removed for clarity. The rear of the steering wheel is shown.
-
Use a mirror to view the rear of the steering wheel to locate where the 3 driver air bag module wire clips attach to the steering wheel hooks.
-
Note the position of the 2 driver air bag module locator pins on the steering wheel for installation.
Using a screwdriver or a suitable tool, release each of the 3 driver air bag module wire clips from the steering wheel hooks.
-
Access the 3 driver air bag module wire clips through the back of the steering wheel cover and push the wire clips toward the center of the
steering wheel to release.
10. Disconnect the driver air bag module electrical connector, then disconnect the horn switch electrical connector and remove the driver air bag
module.