F 250 2WD Super Duty V8-5.4L (2008)
Seats with manual track
3. Remove the bolt and separate the safety belt buckle from the seat track.
-
For passenger seat, remove the safety belt buckle.
-
To install, tighten to 35 Nm (26 lb-ft).
Seats with power track
4. Remove the nut and separate the safety belt buckle from the seat track.
-
For passenger seat, remove the safety belt buckle.
-
To install, tighten to 35 Nm (26 lb-ft).
Driver seat
5. NOTE:
-
Removing the pin-type retainer from the safety belt buckle switch electrical connector can ease removal.
-
Power track shown, manual track similar.
Pull the safety belt buckle switch wire harness and electrical connector through the opening in the side of the seat.
-
Remove the safety belt buckle.
All seats
6. To install, reverse the removal procedure.
-
Make sure the safety belt buckles are accessible to the occupant after installation.
All seats
7. Check the active restraint system for correct operation.
Safety Belt Buckle - Front, Regular Cab, Bench Seat
SAFETY BELT BUCKLE - FRONT, REGULAR CAB, BENCH SEAT