F 250 2WD Super Duty V8-5.4L (2008)
1. Using an appropriate tool, push in the pin hole while pulling the safety belt tongue out of the safety belt buckle.
-
After installation, when inserting the safety belt tongue into the safety belt buckle, make sure the safety belt buckle and safety belt retractor
webbing are not incorrectly twisted.
All safety belt buckles
2. Fold the second row bench seat backrest forward.
-
Remove the safety belt buckle(s) from between the seat backrest and cushion.
LH outboard safety belt buckle
3. Remove the bolt and LH outboard safety belt buckle.
-
To install, tighten to 40 Nm (30 lb-ft).
RH/LH center safety belt buckles
4. Remove the 2 bolts and RH/LH center safety belt buckles.
-
To install, tighten to 40 Nm (30 lb-ft).
RH outboard safety belt buckle
5. Remove the bolt and RH outboard safety belt buckle.
-
To install, tighten to 40 Nm (30 lb-ft).
All safety belt buckles
6. NOTE:
-
When installing a new safety belt buckle assembly, make sure it is installed on the correct side. This is due to the safety belt buckles and
tongues being different sizes from the LH to the RH side.
-
Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
-
Make sure the safety belt buckles are accessible to the occupant after installation.
7. Check the active restraint system for correct operation.
Safety Belt Buckle - Rear, Crew Cab, Bucket Seat
SAFETY BELT BUCKLE - REAR, CREW CAB, BUCKET SEAT