F 250 2WD Super Duty V8-5.4L (2008)
Front Lean Correction Chart
12. If the original front coil spring exceeds the height of the new spring by 13 mm (1/2 inch), install the new front coil spring in the vehicle.
13. If the original front coil spring is shorter than the new spring by at least 13 mm (1/2 inch), remove the low side front coil spring from the vehicle.
Rear lean correction
NOTE: If the recorded rear wheel well difference number is greater than the front, correct the rear lean condition before correcting any front lean
conditions.
14. Using the recorded wheel well difference numbers, the recorded chassis ride height difference numbers and the following repair action chart,
determine what repair action is needed to correct the vehicle lean condition.
Rear Lean Correction Chart
Rear Lean Correction Chart
^
If shim installation is required, continue with this procedure.
15. Support the axle.