F 250 2WD Super Duty V8-5.4L (2008)
20. Remove the valve housing from the holding fixture.
21. Reposition the steering gear in the vise to access the sector shaft seals.
22. CAUTION: Do not allow the screwdriver to make contact with the sector shaft seal bore, or damage to the sealing area may occur,
causing a fluid leak.
Using a screwdriver, remove and discard the sector shaft dust seal.
23. Remove the sector shaft seal snap ring and spacer.
^
Discard the snap ring.
24. CAUTION: Do not allow the seal puller to make contact with the sector shaft seal bore, or damage to the sealing area may occur, causing
a fluid leak.
NOTE: The steering gear sector shaft bearing is not serviceable.
Using a suitable seal puller, remove and discard the sector shaft seal.
^
Inspect the sector shaft seal bore.
