F 250 2WD Super Duty V8-5.4L (2008)
Suspension Strut / Shock Absorber: Service and Repair
Front Suspension
Shock Absorber - F-250, F-350
NOTE: LH shown, RH similar.
Removal and Installation
WARNING: Do not apply heat or flame to the shock absorber or strut tube. The shock absorber and strut tube are gas pressurized and
could explode if heated. Failure to follow this instruction may result in serious personal injury.
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can
result in major service expense. They must be replaced with the same part number or an equivalent part if replacement is necessary. Do not
use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of
correct retention of these parts.
1. NOTE: The shock absorber upper nut and washer are accessed through the engine compartment.
Remove and discard the shock absorber upper nut, washer and bushing assembly.
^
To install, tighten to 63 Nm (46 ft. lbs.).
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
3. Remove and discard the shock absorber lower nut and washer.
^
To install, tighten to 80 Nm (59 ft. lbs.).
4. Remove the shock absorber.
5. To install, reverse the removal procedure.
