F 250 2WD Super Duty V8-5.4L VIN 5 (2006)
All vehicles
6. Connect the OSS sensor.
7. Install the rear transmission mount and lower the transmission onto the crossmember.
8. Install the transmission insulator bolts and nuts.
^
Tighten bolts to 94 Nm (69 ft. lbs.).
^
Tighten nuts to 103 Nm (76 ft. lbs.).
9. Install the driveshaft.
10. Start the engine. Move the transmission range selector lever through all the gear ranges, checking for engagements.
11. With the vehicle in NEUTRAL, engine running and the transmission at normal operating temperature 66 - 77°C (150 - 170°F), check and adjust
the transmission fluid level, and check for any leaks. If fluid is needed, add fluid in increments of 0.24 liter (0.5 pint) until the correct level is
achieved (fluid should be in the cross-hatched area of the fluid level indicator).
