F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
6. Remove the spotlight switch retaining pin.
7. Slide the stoplight switch and booster push rod from the brake pedal pin.
8. Remove the brake pedal motor bolts.
9. CAUTION: The brake pedal and the accelerator pedal must be in the same position before installation. The pedals must be in the completely
rearward (toward the driver) position.
NOTE: Brake pedal motor-to-pedal cable must be routed around the main wiring harness to prevent cable binding.
NOTE: Hand-tighten the bolts.
To install, reverse the removal procedure.