F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
Oil Cooler: Service and Repair
Oil Cooler
Material
Removal
1. Remove the intake manifold.
2. NOTE: Late build shown, early build similar.
Remove the bolts and the Exhaust Gas Recirculation (EGR) cooler supply port cover.
^
Clean and inspect the gasket. Install a new gasket if necessary.
^
Clean and inspect the sealing surfaces.
3. Remove the bolts and the oil filter base.
^
Clean and inspect the gasket. Install a new gasket if necessary.
^
Clean and inspect the sealing surfaces.
4. CAUTION: In the event of a catastrophic engine failure, always install a new oil cooler cover assembly (with oil cooler). Foreign material