F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
6.
Inspect each injector bore for bubbles. (A light and mirror or bore-scope may aid in pinpointing a leak location.) If bubbles are observed,
determine if bubbles originate from the injector sleeve lip (Figure 1) or cylinder head casting. (Figure 2) Refer to cutaway view of the cylinder
head. (Figure 3)
a.
Replace the injector sleeve if found to be leaking at sleeve lip, refer to WSM 303-04C.
b.
Replace cylinder head if leaking through casting, refer to WSM 303-01C.
c.
Flush cooling system, refer to another applicable Technical Service Bulletin (TSB) for proper cooling system flush procedures.
OTHER APPLICABLE ARTICLES: 08-23-01
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
MT082308
Use SLIS Operations If
Actual
Available; Claim Additional
Time
Diagnosis Or Labor
Performed As Actual Time
DEALER CODING
CONDITION
BASIC PART NO.
CODE
6049
01
Disclaimer