F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
EXCESS STOCK RETURN
Excess stock returned for credit must have been purchased from Ford Customer Service Division in accordance with Policy Procedure Bulletin 4000.
Attachment III - Sensor Connector Replacement
OVERVIEW
This program involves replacing the injector control pressure (ICP) sensor connector assembly. The harness connector is replaced utilizing the Rotunda
Wire Splice Tool Kit 164-R5903.
NOTE:
The ICP sensor is located in the right (passenger side) valve cover near the front of the engine. For access to replace the ICP sensor harness
connector, the generator must be removed. On vehicles with dual generators, the upper generator must be removed for access.
GENERATOR REMOVAL
1.
Disconnect the dual batteries.