F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
from where the bolt on the clamp will be located (Figure 1).
3.
After installing the engine end of the duct, position the internal bead of the duct into the groove in the engine elbow and hand torque the clamp to
106 lb-in (12 N.m).
CAUTION
DO NOT OVER-TORQUE THE CLAMP.
4.
Verify the torque on the CAC end of the duct is 106 lb-in (12 N.m).
METAL DUCT KIT INSTALLATION
1.
Remove residue from both connecting ports and the inside surface on both ends of the duct with Motorcraft Metal Brake Parts Cleaner (PM-4).
2.
Install CAC Metal Duct Kit.
3.
After installing new duct on both ports, position the internal bead of the duct into the groove in the engine elbow. Hand torque the clamp to 106
lb-in (12 N.m).
4.
Push the other end squarely and fully onto the CAC port. Hand torque the clamp to 106 lb-in (12 N.m).
NOTE
MAKE SURE THAT THE CLAMP BOLT IS POSITIONED SO THAT IT WILL NOT BE STRUCK BY THE HOOD WHEN CLOSED.
Parts Block
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
OPERATION
DESCRIPTION
TIME
052203A
2004-2005 F Super Duty,
0.4 hr
Excursion: Install
Reinforcing Ring Following
Service Procedure (Do
not use with 6646A,
9600A)
052203B
2004-2005 F Super Duty,
0.4 hr
Excursion: Install Metal
Duct Kit Following Service
Procedure (Do not use
with 6646A, 9600A)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
6C646
42
OASIS CODES: 401000, 497000, 614000
Disclaimer