F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
2. Press the inner and outer pinion bearing cups into the carrier until seated.
^
Use a 0.0381 mm (0.0015 inch) feeler gauge to verify the bearing cups have completely seated in the bearing bores.
^
Lubricate the bearing cups and cone.
3. Seat the outer pinion bearing on the pinion.
1
Seat the inner pinion bearing into the cup by positioning a 152.4 x 152.4 x 152.4 mm (6 x 6 x 6 inch) block of wood under the pinion.
2
Place the original pinion preload spacer onto the pinion.
3
Place the outer pinion bearing onto the pinion.
4
Using a suitable press, seat the outer bearing on the pinion.
4. NOTE: Do not install the pinion seal at this time.
Install the pinion flange.