F 250 2WD Super Duty V8-6.0L DSL Turbo VIN P (2004)
5. Remove the center bearing support bolts.
6. Remove the rear driveshaft assembly.
7. NOTE: Index-mark the driveshaft to transmission flange or output shaft to slip yoke.
For vehicles equipped with a circular flange, remove and discard the bolts.
8. Remove the center bearing support bolts.
9. Remove the front driveshaft.
For vehicles equipped with a slip yoke, lower the driveshaft and slide it rearward off the transmission output shaft.
Plug the extension housing to prevent fluid loss.
10. Clean grease deposits, dirt and rust from the following:
^
The driveshaft yoke areas.
^
All driveshaft components.
^
Wipe the bearing and rubber insulator of the driveshaft center bearing. Do not immerse in solvent.
11. Inspect the following:
^
The universal Joint slip yoke boot for rips or holes. Install a new boot if necessary.
^
The driveshaft center bearing support for wear or rough action. If roughness or wear is evident, install a new driveshaft center bearing support.
^
The center bearing rubber insulator for evidence of hardening, cracking or deterioration. Install a new insulator if necessary.
Installation
