F 250 4WD HD Pickup V8-460 7.5L VIN G EFI (1997)
Wiper Motor Linkage: Service and Repair
Mounting Arm and Pivot Shaft
REMOVAL
1. Remove windshield wiper pivot arms.
2. Remove bottom windshield moulding.
3. Remove the five screws through the access holes across the top of the cowl top vent panel.
4. Open hood and disconnect battery ground cable.
5. Remove the ten screws across the vertical surface attaching the cowl top vent panel to the cowl top.
6. Close the hood part way and carefully lift the cowl top vent panel from the cowl top.
7. Disconnect or remove the radio antenna or lead wire as required.
NOTE: Antenna will disconnect when cowl top vent panel is removed. If antenna becomes disconnected from cowl top outer panel, refer for
removal and installation procedure.
8. Disconnect the hose. Remove the cowl top vent panel.
9. Remove windshield wiper adapter and connecting arm clip connecting windshield wiper mounting arm and pivot shaft windshield wiper motor
drive arm.
10. Remove bolts attaching windshield wiper mounting arm and pivot shaft to the cowl top.
11. Remove windshield wiper mounting arm and pivot shaft from vehicle.
