F 250 4WD LD Pickup V8-281 4.6L VIN W EFI (1997)
-
Install the shoe slippers.
Rear Brake Shoe And Lining
-
Install the rear brake shoe and lining.
CAUTION:The Brake Pads should be replaced in full axle sets only. Do not replace worn rear brake shoe and linings on only one side of the vehicle.
NOTE: When installed, the locator notch on the brake shoe and lining will be located at the upper end of the rear disc brake caliper.
Rear Disc Brake Caliper
-
Install the rear disc brake caliper.
NOTE: Make sure the notches on the upper ends of the brake shoe and linings are seated over the upper shoe slipper.
1
Position the rear disc brake caliper.
2
Install the bolts.
-
Clean the wheel hub mounting surface.
WARNING:ALWAYS REMOVE ANY CORROSION, DIRT OR FOREIGN MATERIAL PRESENT ON THE MOUNTING SURFACES
OF THE WHEEL OR THE SURFACE OF THE WHEEL HUB, BRAKE DRUM OR DISC BRAKE ROTOR THAT
CONTACTS THE WHEEL. INSTALLING WHEELS WITHOUT PROPER METAL TO METAL CONTACT AT THE
WHEEL MOUNTING SURFACES CAN CAUSE THE LUG NUTS TO LOOSEN AND COME OFF WHILE THE VEHICLE
IS IN MOTION, CAUSING LOSS OF CONTROL.
