F 250 4WD LD Pickup V8-281 4.6L VIN W EFI (1997)
Brake Master Cylinder: Service and Repair
Brake Fluid Reservoir
REMOVAL:
WARNING:BRAKE FLUID CONTAINS POLYGLYCOL ETHERS AND POLYGLYCOLS. AVOID CONTACT WITH EYES. WASH
HANDS THOROUGHLY AFTER HANDLING. IF BRAKE FLUID CONTACTS EYES, FLUSH EYES WITH RUNNING
WATER FOR 15 MINUTES. GET MEDICAL ATTENTION IF IRRITATION PERSISTS. IF TAKEN INTERNALLY, DRINK
WATER AND INDUCE VOMITING. GET MEDICAL ATTENTION IMMEDIATELY.
-
Disconnect the brake master cylinder fluid level warning switch.
-
Use a suitable suction device to drain the brake master cylinder reservoir.
-
Carefully pry up on the brake master cylinder reservoir to remove.
INSTALLATION:
-
Install the brake master cylinder reservoir.
NOTE: Whenever replacing the brake master cylinder reservoir, replace the grommets.
1
Lubricate the two grommets with High Performance DOT 3 Brake Fluid C6AZ-19542-AB or DOT 3 equivalent meeting Ford specification
ESA-M6C25-A, DOT 3 and insert the grommets in the brake master cylinder.
2
Press the brake master cylinder reservoir into the grommets until it snaps.
3
Connect the brake master cylinder fluid level warning switch.
4
Fill the brake master cylinder reservoir with High Performance DOT 3 Brake Fluid C6AZ-19542-AB or DOT 3 equivalent meeting Ford
specification ESA-M6C25-A.
