F 250 4WD LD Pickup V8-281 4.6L VIN W EFI (1997)
10. Remove the accelerator control splash shield.
1
Remove the three accelerator control splash shield bolts.
2
Remove the accelerator control splash shield.
11. Disconnect the following electrical connectors:
-
Idle Air Control (IAC) valve electrical connector (A).
-
Differential Pressure Feedback EGR (DPFE) transducer electrical connector (B).
-
Engine Vacuum Regulator (EVR) electrical connector (C).
-
Throttle Position (TP) sensor electrical connector (D).
12. Disconnect the engine cooling system sensor connections.
-
Disconnect the (A) Engine Coolant Temperature (ECT) sensor electrical connector.
-
Disconnect the (B) water temperature indicator sender unit electrical connector.
13. Disconnect the four RH fuel injector electrical connectors.