F 250 4WD LD Pickup V8-281 4.6L VIN W EFI (1997)
6. Connect the solenoid and sensor electrical connectors.
(1) Transmission Fluid Temperature (TFT) sensor.
(2) Shift solenoids.
(3) Torque Converter Control (TCC) solenoid.
(4) Electronic Pressure Control (EPC) solenoid.
7. Replace the fluid filter and seal as required.
CAUTION: If replacing the filter, and the seal remains in the main control bore, carefully use a small screwdriver to remove the seal. Use care
not to damage the main control bore.
NOTE: If the transmission is being repaired for a contamination-related failure, use a new filter and seal. The filter may be reused if no excessive
contamination is present.
8. Position the pan magnet into the transmission fluid pan.