F 250 4WD LD Pickup V8-281 4.6L VIN W EFI (1997)
4. Install the large driveshaft slip yoke boot clamp.
(1) Remove any excess grease from the differential slip yoke boot and driveshaft slip yoke surfaces.
(2) Position the differential slip yoke boot over the driveshaft slip yoke boot groove.
(3) Position the driveshaft slip yoke to specification from the driveshaft weld to U-Joint center line.
(4) Bleed air from the driveshaft slip yoke boot.
(5) Use Keystone Clamp Pliers to crimp the large driveshaft slip yoke boot clamp.