F 250 4WD LD Pickup V8-5.4L SOHC VIN L (1997)
9.
Cut approximately 3 mm (1/8 in) off the grease tube applicator tip.
10.
Before installing the jumper harness, fill the vehicle harness end of the jumper (male pin connector end) with Motorcraft Electrical Grease II
XG-15-A. See Figure 7.
11.
Install the adapter jumper harness by connecting it to both the SCDS and the vehicle harness. Using the provided tie strap, secure the jumper
harness to a nearby component such as the speed control cable or another wire harness.
NOTICE:
Be sure to apply and adequate amount of grease to the vehicle harness connector only. DO NOT apply the grease directly to the connector of the
servo module.
12.
Apply a 5 mm (3/16 in) high bead of Motorcraft Electrical Grease II XG-15-A across the entire width and length of the servo vehicle harness
connector. See Figure 8.