F 250 4WD LD Pickup V8-5.4L SOHC VIN L (1997)
6. Lubricate the lip of the pinion seal and the splines on the pinion shaft with Motorcraft Synthetic Rear Axle Lubricant F112-19580-B or equivalent
meeting Ford Specification WSL-M2C192-A.
7. Install the pinion seal.
(1) Install the outer differential pinion bearing.
(2) Install the oil slinger.
(3) Install the (A) pinion seal using (B) Pinion Seal Replacer.
CAUTION: Installation without the proper tool can result in early seal failure. If the seal becomes cocked during installation, remove it and
install a new one.
8. Position the pinion in the axle housing.
9. Align the (A) rear axle companion flange with the (B) pinion shaft.
NOTE: Disregard the scribe marks if a new rear axle companion flange is being installed.
