F 250 4WD LD Pickup V8-5.4L SOHC VIN L (1997)
a. Clean the front wheel driveshaft joint boot mounting surface.
b. Position the outboard front wheel driveshaft joint boot in the outboard CV joint grooves and position the boot clamps.
3. Use the CV Boot Clamp Installer to install the boot clamps.
NOTE: Tighten the through-bolt until the installer is in the closed position.
4. Install the two outboard clamp protectors.
5. Position the inboard clamp protector and the boot clamp on the halfshaft assembly.
6. Position the inboard front wheel driveshaft joint boot.