F 250 4WD Pickup V8-302 5.0L (1986)
a.
Install a 1" (25.4 mm) piece of heat shrink tubing over each end of wire.
b.
Install the small female spade terminal onto the red wire and the large female spade terminal onto the black wire.
c.
Crimp and solder new terminals onto the wires.
d.
Put shrink tubing over the new crimp and solder connection.
6.
Install wires on the RFI noise filter terminals.
NOTE:
BE SURE TO OBSERVE POLARITY MARKINGS.
Go to Step 12.