F 250 4WD Pickup V8-302 5.0L (1986)
Ranger/Bronco II
E0TZ-3B440-A
Camber Adjuster -
AM
F-Series/Bronco
E0TZ-3B440-B
Camber Adjuster -
AM
F-Series/Bronco
E0TZ-3B440-C
Camber Adjuster -
AM
F-Series/Bronco
E0TZ-3B440-D
Camber Adjuster -
AM
F-Series/Bronco
E3TZ-3B440-A
Camber Adjuster -
BM
Ranger/Bronco II
E3TZ-3B440-B
Camber Adjuster -
AM
Ranger/Bronco II
E3TZ-3B440-C
Camber Adjuster -
AM
Ranger/Bronco II
E3TZ-3B440-D
Camber Adjuster -
AM
Ranger/Bronco II
E0TZ-5A313-A
Caster Wedge
C
E0TZ-5A313-B
Caster Wedge
BM
E0TZ-5A313-C
Caster Wedge
RM
OTHER APPLICABLE ARTICLES: 87-4-16
SUPERSEDES:
89-19-13, date 9/20 89
WARRANTY STATUS: INFORMATION ONLY
OASIS CODES:
3100, 3200, 3300
Technical Service Bulletin # 87416
Date: 870225
Steering - Pulling or Drifting
^
STEERING - PULL OR DRIFT - CASTER Article No.
ADJUSTMENT SERVICE KIT
87-4-16
^
SUSPENSION - FRONT - CASTER ADJUSTMENT SERVICE KIT
LIGHT TRUCK 1980-86 F-150 (4x4), BRONCO
ISSUE:
A steering drift or pull may be caused by excessive front wheel side-to-side caster angle differences.
ACTION:
If a front axle alignment check shows excessive (more than 3/4 degree split) side-to-side caster angle difference causing the vehicle to drift
or pull, install a new caster adjustment kit (E0TZ-3K064-A) which allows the front axle side-to-side caster angles to be changed up to 2-1/2
degrees in 1/2 degree increments. New front axle to radius arm brackets must also be replaced when the caster kit is installed. Refer to the
following service procedure for step-by-step instructions.
NOTE THE FOLLOWING INFORMATION BEFORE DOING WORK ON THE VEHICLE.
To correct caster side-to-side difference of up to 1- 1/2 degrees, install a caster adjuster plate on the radius arm that has the lower caster reading.
Adjuster plates are identified R.H. and L.H.
To correct caster side-to-side difference more than 1-1/2 degrees, install the caster plate on both radius arms. Installing both plates will allow a caster
split change of 2-1/2 degrees (+1-1/2 degrees on the low caster side, -1 degree on the high caster side).
1.
Remove radius arm from vehicle.