F 250 4WD Super Duty V10-6.8L VIN V (2005)
Rear Door Latch: Service and Repair
Push Button Rod
Bellcrank, Rear Door, Crew Cab
PUSH BUTTON ROD - BELLCRANK, REAR DOOR, CREW CAB
Removal and Installation
1. Remove the rear door trim panel.
2. Remove the rear door push button rod.
3. Remove the rear door push button rod linkage.
4. CAUTION: When drilling out the push button rod bellcrank rivet, do not oversize the hole in the door sheet metal.
Remove the push button rod bellcrank.
1
Remove the rivet mandrel (center).
2
Drill out the rivet.
3
Remove the push button bellcrank.
5. NOTE: If a new component is to be installed, refer to the Ford Master Parts Catalog for specific part information.
To install, reverse the removal procedure.
Linkage, Horizontal, Rear Door, Crew Cab
PUSH BUTTON ROD - LINKAGE, HORIZONTAL, REAR DOOR, CREW CAB
Removal and Installation
1. Remove the rear door trim panel.
2. Remove the guide clip from the door lock linkage.