F 250 4WD Super Duty V10-6.8L VIN V (2005)
5. Remove the insulator.
6. NOTE:
-
Do not reuse body support mounting fasteners. New fasteners must be installed for each fastener that has been removed or loosened.
-
No lubricants of any kind are to be used during body insulator installation.
To install, reverse the removal procedure.
Body Support - Rear, SuperCab, Upper
BODY SUPPORT-REAR, SUPERCAB, UPPER
Removal and Installation
1. CAUTION: When removing upper body insulators, all other body mount support bolts must be loose before raising the vehicle cab to
prevent permanent structural damage from occurring to the vehicle cab.
Remove the rear lower body insulator.
2. Remove and discard the opposite side rear body insulator bolt.
3. Remove and discard the left and right front body insulator bolts.
4. Raise the vehicle cab enough to allow removal of the insulator.
5. Remove the insulator.