F 250 4WD Super Duty V10-6.8L VIN V (2005)
All seats
7. Position the side trim cover. Install the three trim cover screws.
-
The seat backrest pivot bolt shaft must be inserted into the cover standoff.
8. Push the rearward lower corner of the side shield to engage the metal retaining clip.
9. Position the lumbar adjuster control and install the two mounting screws. Install the adjuster knob.
10. Position the seat back recliner lever cover and install the screw.
11. Install the front seat.
Rear Seat Cushion - SuperCab
REAR SEAT CUSHION - SUPERCAB
Removal and Installation
1. NOTE: 60 percent seat is shown, 40 percent seat is similar.
Remove the seat.
