F 250 4WD Super Duty V10-6.8L VIN V (2005)
Verify the camshaft sprocket and timing chain scribe marks are still in alignment.
9. CAUTION: Do not allow the roller followers to move out of position when installing the camshaft.
Install the camshaft bearing caps in their original locations.
^
Lubricate the camshaft bearing caps with clean engine oil.
^
Position the front camshaft bearing cap.
^
Position the remaining camshaft bearing caps.
^
Install the bolts loosely.
10. Tighten the RH camshaft bearing cap bolts in 2 stages:
^
Stage 1: Tighten to 8 Nm (71 inch lbs.) in the sequence shown.
^
Stage 2: Tighten an additional 45 degrees.