F 250 4WD Super Duty V10-6.8L VIN V (2005)
Air Door Actuator / Motor: Service and Repair
Vacuum Control Motor
Panel/Defrost Door
VACUUM CONTROL MOTOR - PANEL/DEFROST DOOR
Removal and Installation
1. Remove the extension duct.
2. Remove the panel/defrost door vacuum control motor.
1
Disconnect the vacuum line.
2
Remove the pushnut.
3
Remove the screws.
4
Remove the panel/defrost door vacuum control motor.
3. To install, reverse the removal procedure.
-
Install a new pushnut.
Air Inlet Door
VACUUM CONTROL MOTOR - AIR INLET DOOR
Removal and Installation
1. CAUTION: Do not attempt to bend any part of the lever. It is brittle and will break.
Remove the air inlet door vacuum control motor.
1
Disconnect the vacuum line.
2
Remove the screws.
3
Rotate the vacuum control motor to disengage the lever and remove the air inlet door vacuum control motor.
2. To install, reverse the removal procedure.
Panel/Floor Door
VACUUM CONTROL MOTOR - PANEL/FLOOR DOOR
Removal and Installation