F 250 4WD Super Duty V10-6.8L VIN V (2005)
Fuel Pump Control Unit: Service and Repair
FUEL PUMP DRIVER MODULE (FPDM)
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Disconnect the FPDM electrical connector.
4. Remove the FPDM nuts.
-
To install, tighten to 10 Nm (89 lb-in).
5. Remove the FPDM.
6. To install, reverse the removal procedure.