F 250 4WD Super Duty V10-6.8L VIN V (2005)
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the battery ground cable.
3. Disconnect the heated oxygen sensor (HO2S) electrical connector.
4. Using the special tool, remove the HO2S.
-
Apply penetrating lubricant to the HO2S to assist in removal.
Installation
1. Using the special tool, install the HO2S.
-
To install, tighten to 46 Nm (34 lb-ft).
-
Apply a light coat of high temperature nickel anti-seize lubricant to the HO2S threads prior to installation.
2. Connect the HO2S electrical connector.
3. Connect the battery ground cable.