F 250 4WD Super Duty V10-6.8L VIN V (2005)
Tie Rod End: Service and Repair
Tie Rod End - Outer, RH
Tie Rod End - Outer, RH, F-250, F-350, 4x4, and F-450, F-550
Special Tool(s)
Removal and Installation
NOTE: Replace the tie-rod end if the ball stud is loose in the socket or the tie-rod end is bent. Replace the steering linkage stud dust seal if any nicks,
cuts, or tears are present. Do not attempt to straighten steering linkage components.
1. Place the steering wheel in the straight-ahead position.
2. Remove the RH wheel and tire assembly.
3. Loosen the adjusting sleeve nut.
4. Loosen the adjusting sleeve bracket nut.