F 250 4WD Super Duty V10-6.8L VIN V (2005)
Suspension Strut / Shock Absorber: Service and Repair
Rear
Shock Absorber - F-250, F-350, Ford Axle
Removal and Installation
CAUTION: Suspension fasteners are critical components because they affect performance of vital components and systems and their failure can
result in major service expense. Install new components with the same component number or an equivalent component if installation is necessary. Do
not use an installation component of lesser quality or substitute design. Torque values must be used during reassembly to make sure of correct
retention of these components.
CAUTION: The low pressure gas shock absorbers are charged with nitrogen gas. Do not attempt to open, puncture or apply heat to shock absorbers.
NOTE: Super Duty F-250, F-350 Ford axle shown, Super Duty F-350 Dana axle similar.
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Using a suitable Jack, support the rear axle.
3. Remove the shock absorber lower retaining nut and bolt.
4. Remove the nut from the upper shock absorber mounting bracket and remove the shock.
5. To install, follow the removal procedure in reverse order, using new fasteners.
