F 250 4WD Super Duty V10-6.8L VIN V (2005)
Seals and Gaskets: Service and Repair
Manual Control Lever Shaft and Seal
Manual Control Lever Shaft and Seal
Special Tool(s)
Removal
1. With the vehicle in NEUTRAL, position on a hoist.
2. Disconnect the shift cable end.
3. Remove the transmission fluid pan, gasket and filter. For additional information, refer to Fluid Pan, Gasket and Filter.
NOTE: The pin should be driven up through the manual lever.
4. Remove and discard the manual valve detent lever shaft retaining pin.