F 250 4WD Super Duty V10-6.8L VIN Y (2006)
Gear Sensor/Switch: Service and Repair
Gearmotor Encoder Assembly
Material
Material
Removal and Installation
1. Set the mode select switch to the 4WD HIGH position.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. Disconnect the gearmotor encoder assembly harness connectors.
4. Remove the 3 gearmotor encoder bolts and the gearmotor encoder assembly.
^
To install, tighten to 20 Nm (15 ft. lbs.).
5. Remove the grease from the motor adapter and check for any nicks or burrs. If any damage is found, repair or install a new adapter as necessary.
6. To install, reverse the removal procedure.
^
Apply a coat of grease to the new motor adapter.