F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
6. Remove the Manifold Absolute Pressure (MAP) sensor and bracket assembly (if equipped).
1
Disconnect the electrical connector.
2
Disconnect the clamp and disconnect the vacuum line.
3
Remove the nuts and the MAP sensor and bracket assembly.
7. Loosen the clamps and remove the intercooler tube (if equipped).
8. Disconnect the heater hose coupling from the underbody auxiliary heater lines.
All vehicles
9. Disconnect the manifold and tube assembly.
^
Discard the O-ring seal.
10. Detach the evaporator inlet from the clip.
