F 250 4WD Super Duty V10-6.8L VIN Z CNG (2003)
5.
Replace both front leaf springs. Refer to the spring selection table in this TSB (Figure 2). If the build date is between March 20, 1999 and
November 25, 2001, replace the Steering Gear and the Pitman Arm (Part Numbers 2C3Z-3504-AARM and YC3Z-3590-CA respectively). Adjust
the mesh load to 5.0 to 6.0 lb-in. Refer to the Workshop Manual, Section 211-00 for repair procedure. Set cross caster to (-0.5°). Use caster slugs
if necessary. Set caster, camber, toe and clear vision within specifications. See Section 204-00 of the appropriate Workshop Manual. Test
operation.
6.
Install new pads with the same edge code. Machine the rotors using Rotunda Hub-Mount Brake Lathe / Pro-Cut (201-00002) or replace the rotors.
Burnish the linings by a minimum of 50 brake applications from 40 MPH (64 km/h) to stop. Provide sufficient lime between brake applications so
that linings do not smoke or overheat. Check operation. If the condition is still present, burnish the linings once more and check operation.
