F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
Antenna: Service and Repair
Antenna
ANTENNA
Removal and Installation
1. Remove the RH A-pillar lower trim panel.
2. Disconnect the antenna.
1
Disconnect the antenna-to-antenna lead-in cable electrical connector.
2
Release the grommet.
3. Remove the antenna mast.
4. Remove the RH cowl vent grille.
5. Using an appropriate tool, remove the antenna mast boot.
6. Remove the 3 screws and the antenna.
-
Route the cable portion of the antenna through the hole where the grommet was located, and out of the vehicle through the cowl hole.
7. To install, reverse the removal procedure.