F 250 4WD Super Duty V8-6.4L DSL Turbo (2008)
4. Using the Handle and Axle Bearing Installer, drive the inner bearing cup into the fully seated position.
5. NOTE: The wheel hub bearings must be prelubricated with grease prior to installation. Pack each bearing with a bearing packing tool. Also apply
grease to the thrust surface of the bearing.
Position the greased inner bearing in the inner bearing cup.
6. NOTICE: The slinger must be correctly centered on the bearing or damage to the components can occur.
NOTE: The grease on the bearing and slinger holds the slinger in position during seal installation.
Position the slinger on the greased bearing with the tangs facing the bearing.
7. With the slinger in place, position the wheel hub seal in the wheel hub bore and place the Handle and Wheel Hub Oil Seal Installer on the wheel
hub seal.
